Leica-biosystems IPS Manuale Utente Scaricare il pdf (Pagina 61)

Leica IP S

7. Troubleshooting

7.1 Malfunctions

Confirm elimination

of error

If the printer malfunctions during printing, a corresponding error

code is displayed and simultaneously the LED in the ERROR button

starts flashing.

How to eliminate the problem:

• Determinethecauseoftheerror—seeerrorlist(Chapter 7.3).

• Removeobstruction(s);openlidifrequired.

• Important!

Remove all slides which are still in the chute, in or next to the specimen

slide carrier or in the drying module!

These specimen slides should not be used again.

• ReclosethehoodandpresstheERROR button to confirm to the printer

that the source of the error has been eliminated.

• Theprinterthenverifieswhetherallprocessingpathsareunobstructed

and whether the source of the error has been eliminated.

• Iftherearestillsomeobstructionsleft,orifthesourceoferrorhasnot

been thoroughly eliminated, the printer displays another error message.

• Interruptedprintjobsareresumedwherepreviouslyleftoff.

• Ifanerrormessageisdisplayedseveraltimesalthoughallpossible

causes have been eliminated, a Reset should be carried out.

Reset:

• Pressandrelease LOADED and ERROR simultaneously.

• AResetrestorestheprintertothesamestateasdirectlyafterswitching

on. All print jobs in the print queue are deleted.

• IfthesameerrorcontinuestobedisplayedevenafteraReset,switchthe

printer off via the power switch (back panel) and, after a short waiting

period of approx. 30 sec., switch it back on. If this does not eliminate the

problem either, call Leica Technical Service.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 69 70

Nessun commento

Leica-biosystems IPS Manuale Utente Pagina 61